Commercial Electrical Energy Saving Device

ENERGY SAVINGS PLAN SIGN-UP & PRODUCT ORDERS &
CUSTOMER SERVICE (860) 781 6666

The DCS Energy Miser, with the use of capacitors and new technology, reduces the electricity used by a building. It does this by increasing the building’s “Power Factor” – its electrical energy efficiency.

Without The DCS Energy Miser, the Power Factor of a building can be anywhere from .70 to .95. In other words, the building is using only 70% to 95% of the electricity that is coming through the electric meter, and showing up on the electric bill. The DCS Energy Miser improves the Power Factor and energy efficiency of your building and thus reduces the amount of electricity that your motors use. So when you are using your refrigerator, freezer, dishwasher, washer, spa, pool, dryer, air conditioner, heating system or ceiling fans your building will require less electricity. This reduces your electric bill by up to 20%. For more information on Power Factor and how it can

increase utility bills please check out Alliant Energy, a Wisconsin Power Utility, website

at www.alliantenergy.com (click link)

It also reduces 6,000 pounds of carbon from your building’s carbon footprint. The Miser helps the environment and reduces power demand on your electric grid while putting more money in your pocket. Go to the ORDER NOW PAGE TO ORDER YOUR DCS ENERGY MISER!

DCS Energy Miser Facts

• Works with three phase electric systems. The electric panel that the Miser is to be installed to needs to have 400 amps or less of inductive load (motors).

• Completely safe (if installed correctly) and will not feed electricity back to the grid in the event of a power failure.

• Size is 12"H X 12"W X 6"D and weighs 12 lbs.

• Provides additional protection from any surges from the electrical grid that could harm your electrical devices, refrigerators, washers, dryers, and computers.

• Has a three year limited warranty.

• UL listed and approved.

GO TO THE ORDER NOW PAGE FOR ORDERING INFORMATION

Miser Guarantee

If the DCS Energy Miser fails to reduce your electric use in your building you will receive a full refund (documentation is required and de-installation & shipping the Miser back to DCS Energy is the financial responsibility of the owner). Refund must be requested within 60 days of purchase

Installation Instructions

The DCS Energy Three Phase Miser is usually installed by an electrician in less than an hour. The electrician or installer will need sealtight flex conduit, electric box, electric cable, 40 AMP three pole circuit breaker and screws to secure the Miser. Average cost of materials is $50 and you would also pay the electrician for the installation hour.

Installation instructions are included with the unit. Installation requires the connecting of the three red leads to the dedicated three pole 40 AMP circuit breaker and connecting the ground (green lead) to the ground of the electric panel..

The building owner is responsible for any permits that may be needed for the installation.

. Energy Miser Installed (far)