FOR PRODUCT ORDERS GO TO ORDER MISER NOW PAGE & FIND A DEALER
CUSTOMER SERVICE (860) 781 6666
The DCS Energy Miser, with the use of capacitors and new technology, reduces the electricity used by a building. It does this by increasing the building’s “Power Factor”– which improves its electrical energy efficiency.
Without The DCS Energy Miser, the Power Factor of a building can be anywhere from .70 to .95. In other words, the building is using only 70% to 95% of the electricity that is coming through the electric meter, and showing up on the electric bill. The DCS Energy Miser improves the Power Factor and energy efficiency of your building and thus reduces the amount of electricity that your motors use. So when you are using your refrigerator, freezer, dishwasher, washer, spa, pool, dryer, air conditioner, heating system or ceiling fans your building will require less electricity. This reduces your electric bill by up to 20%. If you want to hear from an electric utility about Power Factor and how they charge customers with a bad Power Factor go to Alliant Energy from Wisconsin at www.alliantenergy.com.
It also reduces 6,000 pounds of carbon from your building’s carbon footprint. The Miser helps the environment and reduces power demand on your electric grid while putting more money in your pocket. Purchase The DCS Energy Miser now!
DCS Energy Miser Facts
• Works with the regular single phase electric systems of a home or small business. 600 Amp service or less is required.
GO TO THE ORDER NOW PAGE FOR ORDERING INFORMATION
Miser GuaranteeIf the DCS Energy Miser fails to reduce your electric use in your building you will receive a full refund (documentation is required and de-installation & shipping the Miser back to DCS Energy is the financial responsibility of the owner). Refund must be requested within 60 days of purchase
Installation InstructionsThe DCS Energy Single Phase Miser is usually installed by an electrician in less than an hour. The electrician or installer will need sealtight flex conduit, electric box, electric cable, 20 AMP two pole circuit breaker (40 amp three pole breaker for commercial-grade Three Phase Miser) and screws to secure the Miser. Average cost of materials is $50 and you would also pay the electrician for the installation hour.
Installation instructions are included with the unit. Installation requires the connecting of the two red leads to the dedicated two pole 20 AMP circuit breaker (one at each end or three red leads for three phase system) and connecting the ground (green lead) to the ground of the electric panel.